Service Menu Procedures; Figure 2.19 Service Menu, Dt3 Print Station Software - Kodak Versamark DS5600 Series Operator's Manual

Table 2.3 Service menu function
Item
1 Ready - steps
2 Clean - service
3 Shut down
4 Vacuum/ink fill
5 -----------
6 Clean - install

Service Menu Procedures

Use the Service Menu (Figure 2.19) to access functions used for
operator maintenance procedures. Check with a service technician before
starting these procedures. Some service procedures require specific
information about the system, for example: when using a standard ink
there are 15 steps in the Ready - Steps function, but with a special ink,
there could be more steps.
Figure 2.19
Choose a function, enter the number
Table 2.3 summarizes the procedures done using the selections on the
Service Menu.
Description
Brings the printhead to Ready under direct operator control. The print station
progresses through states 1-12. However, to progress to states 13, 14, and 15, you
must press the S
PACEBAR
trying to determine print quality issues. Selecting this function displays the Step To
NOTE1
Ready status screen.
Starts a 3-minute printhead clean cycle with sonic stimulation. Typically, this function
is used to clear print defects such as streakers, crooked jets, or charge shorts. Refer
to Chapter 3, "Messages" for symptoms of print problems. Selecting this function
displays the Service Clean status screen.
Shuts down the printhead. Typically used at the end of the day or prior to changing
the printhead or ink in use. Selecting this function displays the Shutdown Printhead
status screen.
Used to fill the print station ink tank. Selecting this item displays the Vacuum/Ink Fill
status screen.
No Function.
Starts a 10-minute printhead clean cycle with sonic stimulation. Typically, this
function is used to clean a newly installed printhead. It can also be used to clean the
printhead after the print station has been shut down for several days. Selecting this
item displays the Clean - Install status screen.
Service Menu, DT3 print station software
** SERVICE MENU **
Function Selections
1 Ready - steps
2 Clean - service
3 Shut down
4 Vacuum/ink fill
5 --------
6 Clean - install
7 Sequence summary
8 Control menu
9 Parameters menu
Press F1/F2 key for HELP.
to advance to ready. Typically used to looks at jets when
Chapter 2. Operation
Print Station Operation
Operator Guide 37