Print Station Operation; Keyboard Controls; Figure 2.12 Fluid Controller Software Title Screen - Kodak Versamark DS5600 Series Operator's Manual

Print Station Operation

The CS150 cannot control or display status information about a Kodak
Versamark DT3 Print Station or wide-format printhead (Kodak Versamark
DH5300, Kodak Versamark DH6240 or Kodak Versamark DH6300). The
DT3 must be controlled using its operator terminal. One DT3 operator
terminal can share the PC used by the CS150, but the second DT3 has its
own separate PC. Operator procedures are the same regardless of which
PC is used. This section describes these procedures.

Keyboard Controls

The keyboard is the primary interface to the DT3 print station software.
The following commands can be entered using the keyboard:
• On a PC shared with the CS150 software, please press: S
L , S
OCK CROLL
terminal display.
• Press C
TRL
printhead).
• Press
F1
Caution: Pressing after entering standby mode through pressing C
F1
up the print station.
• Press
F2
Pressing
containing the message: There are no pending errors
• Press
F8
Pressing
present has no effect on print station operation
• Press
F10
print station and printhead, the versions of software installed, and the
type of ink in use.
• Press E
SC
menu or screen. Pressing E
• Press any key to progress past the initial screen displayed by the DT3
print station software (Figure 2.12). The next screen displayed is the
Control Menu used for all operator procedures (see the next
section).
Figure 2.12
L , U A to switch to the DT3 operator
OCK P RROW
+ Z to place printhead in standby mode (ink circulating to
to see Help information for any screen or menu.
for an explanation of a displayed error.
when no error is present results in a dialog box
F2
to clear any error that temporarily prevents printing.
when no error is present or when a continuous error is
F8
to display information about the hours of operation for the
to leave the information screen and return to the previous
also clears any temporary errors.
SC
Fluid controller software title screen
Fluid Controller Software
Release 5.xxx
Serial Number: xxxx
Press any key
Chapter 2. Operation
Print Station Operation
CROLL
+ Z locks
TRL
.
.
(C) Copyright
Eastman Kodak Company
1995-2007, All rights reserved
Operator Guide
,
31