Status Messages, Lcd Messages And Led Behaviors - Kodak VERITE Craft 6 Extended User Manual

Status messages, LCD messages and LED behaviors

The Status information will report problems with the unit. Take the proper action by referring to the following table.
» Refer to "Check print status from your PC" on page 29.
LED lighting patterns
Blinking 1
Lights up for 1 sec.
Lights up very rapidly
Blinking 2
than 1 sec.
Blinking very rapidly 2 times
Blinking 3
sec.
Blinking 4 Blinking very slowly
Status messages LCD messages
Ready
Printer is not found (No Error
message)
Insert Paper
Please insert paper
Load paper
into the top tray
and press
Cancel
Paper Jam
Clear jam or remove
the loaded material
(Printing paper
from the rear tray and
jammed)
then press
Material Jam
Material Jam
Clear jam and
(Printing material press
jammed.)
English
No light for 1 sec.
No light for more
No light for 1
LED behaviors
－
blinks as
.
pattern 1
Start
Paper Jam
blinks as
pattern 1
.
blinks as
.
pattern 1
Material LED
Wireless LED
Power LED
Blinking 5 Blinking slowly
Blinking 6 Blinking rapidly
Blinking 7 Blinking very rapidly
Blinking very rapidly 4 times
Blinking 8
sec.
Blinking 9 Blinking slowly (in Power-On mode)
Unit status or possible causes
Communication failed on the unit.
Check the AC plug is connected to the AC outlet
–
properly, the unit is turned On or the connection
environment (USB, Wireless) to the unit. Then
follow the procedures by showing the help text
on your connected unit.
If this error occurs occasionally, refer to the
●
latest troubleshooting by visiting our
website at www.kodakverite.com/support
If you cannot solve the problem,
●
disconnect the AC plug and contact an
Authorized Service Center.
Insert Paper.
Check the Top tray.
–
Set specified paper in the Top tray and
●
then press .
A paper jam has occurred inside of the unit.
Firmly grasp both sides of the jammed paper,
–
then slowly pull it out.
Press , to restart the rest of the print job.
A material jam has occurred inside of the unit.
Firmly grasp both sides of the jammed material,
–
then slowly pull it out.
Press , to restart the rest of the print job.
75
indicated by
— —
— — — indicated by
— — — — indicated by
Refer to
"Insert paper into the Top
tray" on page 30.
"Clearing paper/material
jam in the unit" on
page 68.
"Clearing paper/material
jam in the unit" on
page 68.
Continued on next page.
No light for 2
－