Messages - Siemens SINUMERIK 802D sl Programming And Operating Manual

Messages

7.1 Messages
Functionality
The meanings of the messages listed below differ from those given in the general
"SINUMERIK Diagnostics Guide":
10631
10631
10631
10631
PLC alarm messages are specially configured for the "Manual Machine Plus" system in the
shipped version of the "Manual Machine Plus" software.
The following list of PLC alarm messages applies, unless the machine manufacturer has
defined an alternative or additional list of errors.
700000
700001
700002
700003
700004
700005
700006
700007
700008
700009
700010
700011
700012
700013
700014
700015
700016
700017
700018
700019
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
+X limit stop reached
+X limit stop reached
-Z limit stop reached
+Z limit stop reached
REFERENCE POINT ON X AXIS NOT REACHED
REFERENCE POINT ON Z AXIS NOT REACHED
POSITION OF SPINDLE DIRECTION SWITCH IS ILLEGAL
INCORRECT SPINDLE DIRECTION ACTIVATED
NO VALID SPINDLE/FEED TYPE
RUNTIME MONITORING JOG SELECTION PROGRAM
SPINDLE OVERRIDE NOT 100%
SPINDLE NOT SWITCHED ON
FEED OVERRIDE = 0%
WITH/WITHOUT FEED?
DIRECTION CANNOT BE REVERSED IN THREAD
DRIVE NOT READY
I2/T ALARM FROM I/RF MODULE
MOTOR OVERHEATING
COOLANT TOO LOW
7
123