Siemens SINUMERIK 802D sl Programming And Operating Manual page 35

Controlling the axes and spindle
In manual machining mode, the axes and spindle can be controlled by the following
methods:
● The compound slide rest is controlled by:
● The spindle is controlled by:
Values displayed in the position display and T, F, S
Figure 5-2
Displayed values Meaning
In front of axis letters •
+/-
S value/S type % •
•
F value/F type % •
•
T value •
D value •
INC value •
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
5.2 Display and operator control optios in the main screen for "Manual Machine Plus"
– Handwheels (Page 39) for the X and Z axes, or
– Axis direction switch (Page 39)
– Spindle direction of rotation switch (Page 40)
Main screen for "Manual Machine Plus", position display relative
Current traversing direction of axes
The programmed value for either the spindle speed (rev/min) or the cutting rate (m/min)
The display corresponds to the settings for the machining technology data.
Current position of the spindle override switch in %.
Programmed feed value
in either "m/min" or "mm/Rev", depending on the settings for the machining technology data.
Current position of the feedrate override switch in %.
Tool number of the tool used
Tool offset applied
Handwheel pulse weighting setting
Manual machining
35