Siemens SINUMERIK 802D sl Programming And Operating Manual page 110

Machining the machining step program manually
5.4 Manual machining using cycles (functions)
Inserting a traversing block in the program.
Inserting a roughing cycle in the program.
Change into the dialog box for roughing cycles (Page 84).
Inserting a drilling cycle in the program.
Change into the dialog box (Page 60) for the drilling cycles (Page 62).
Inserting a groove/cutting cycle into the program.
Change into the dialog box for the groove/cutting cycles (Page 65).
Inserting a thread cycle
Change into the dialog box for the thread cycles (Page 76).
Change into the dialog box for machining simulation (Page 117).
The selected step program is saved by pressing the "Execute" softkey.
This softkey opens the screen form in which the machining (Page 120) step program is
actually executed:
The softkey function changes from "Execute" to "Exec. here" by pressing the <ETC> key.
By pressing the softkey "Exec. here" the function changes into the screen form in
whichMachining (Page 120) should be realized.
In this case, the machining step program is executed from the current cursor position in the
machining step program (marked step in the program).
110
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning