Teach In - Siemens SINUMERIK 802D sl Programming And Operating Manual

Machining the machining step program manually

6.2 Teach In

6.2 Teach In
Functionality
Using this function, an approached axis position can be directly entered into a specific
traversing block.
Operating sequences
1. You can reach the "Teach In" function in the machining step program by pressing the
114
"Teach In" softkey.
Figure 6-10 Selecting the "Teach In" function
The controller switches to the manual machining screen forms of axis-parallel turning,
taper turning and radius turning.
Figure 6-11 Executing "Teach In" - axis-parallel roughing machining mode
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning