Siemens SINUMERIK 802D sl Programming And Operating Manual page 86

Manual machining
5.4 Manual machining using cycles (functions)
Parameter
Chamfer/radius
Chamfer/radius
Chamfer/radius
Max. infeed depth
Finishing allowance
The following possibilities exist for the position of the geometry:
86
Description
F1 Depending on the option selected, this value forms either a transition radius
(display "RND") or a transition chamfer (display "Chamfer CHR" or "Chamfer CHF")
of less than 45 between the end face and the inside diameter of the "step". You
0
can toggle between RND / CHR / CHF using the toggle key. An input value of 0.0
switches this function off.
Two types of dimensioning are possible with the chamfers:
in the case of chamfer CHR, the value specifies the width of the chamfer in the
•
direction of the movement,
in the case of chamfer CHF, the value corresponds with the length of the
•
chamfer.
F2 Depending on the option selected, this value forms either a transition radius
(display "RND") or a transition chamfer (display "Chamfer CHR" or "Chamfer CHF")
of less than 45 between the end face and the inside diameter of the "step". You
0
can toggle between RND / CHR / CHF using the toggle key. An input value of 0.0
switches this function off.
Two types of dimensioning are possible with the chamfers:
in the case of chamfer CHR, the value specifies the width of the chamfer in the
•
direction of the movement,
in the case of chamfer CHF, the value corresponds with the length of the
•
chamfer.
F3 Depending on the option selected, this value forms either a transition radius
(display "RND") or a transition chamfer (display "Chamfer CHR" or "Chamfer CHF")
of less than 45 between the end face and the inside diameter of the "step". You
0
can toggle between RND / CHR / CHF using the toggle key. An input value of 0.0
switches this function off.
Two types of dimensioning are possible with the chamfers:
in the case of chamfer CHR, the value specifies the width of the chamfer in the
•
direction of the movement,
in the case of chamfer CHF, the value corresponds with the length of the
•
chamfer.
m1 Enter the maximum infeed depth for roughing. The internal infeed calculation
ensures that the infeed is as uniform as possible throughout the roughing operation.
This entry value represents the maximum value possible and is therefore not
exceeded.
m2 Finishing allowance in the X axis (m2x)
Finishing allowance in the Z axis (m2z)
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning