Siemens SINUMERIK 802D sl Programming And Operating Manual page 104

Manual machining
5.4 Manual machining using cycles (functions)
References
The function "Machine contour" is described in detail in the SINUMERIK 802D sl Turning
Programming and Operating Manual in the chapter "Part programming; Free contour
programming, ... Define a start point".
Rather than the auxiliary chart, the function displays the entered contour section.
Figure 5-66
104
Graphic view of a contour section
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning