Siemens SINUMERIK 802D sl Programming And Operating Manual page 100

Manual machining
5.4 Manual machining using cycles (functions)
Input fields
The input fields in the "Roughing F" screen form have the following meanings:
Parameter
Length
Diameter
Diameter
Max. infeed depth
Finishing allowance
The following option is available for the position of the geometry:
Figure 5-61
100
Description
l Enter here the length of the end face to be cut, taking the contour start position
("Reference z0") in the longitudinal axis (Z axis) as the starting point.
d1 External diameter of the end face to be cut (absolute position of the X axis in the
diameter).
d2 Internal diameter of the end face to be cut (absolute position of the X axis in the
diameter).
m1 Enter the maximum infeed depth for roughing. The internal infeed calculation
ensures that the infeed is as uniform as possible throughout the roughing operation.
This entry value represents the maximum value possible and is therefore not
exceeded.
m2 Finishing allowance in the X axis (m2x)
Finishing allowance in the Z axis (m2z)
Roughing cycle F, position "Outside left"
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning