Siemens SINUMERIK 802D sl Programming And Operating Manual page 63

Notice: If "Time feed" is selected in the "Machining technology data" screen, in order for the
pitch to be calculated correctly, the spindle override weighting must be set to "100%".
Otherwise, the tapping tool or workpiece may be damaged!!
->Prior to NC start, check that the spindle override weighting is set to 100%!
Operating sequences
You can access the drilling cycle overview by pressing the softkey "Drilling" in the basic
screen for "Manual Machine Plus".
Figure 5-24
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
DANGER
Drilling cycle overview - "Tapping" selected
5.4 Manual machining using cycles (functions)
Manual machining
63