7. If you press "Cancel", the tool change only takes place in this step, or
8. Press "Cancel" to confirm the message.
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
if you press "OK", the tool is also changed in all subsequent program steps.
Figure 6-8
Tool change in the machining step program, confirmation
The active tool is inserted into the step program as machining step.
Figure 6-9
Tool change in the machining step program
Note
If the tool change is to be performed without travelling to a fixed point, travel to a safe
machine position beforehand and save this point as work step in the step program.
Machining the machining step program manually
6.1 Tool change in the machining step program
113