Siemens SINUMERIK 802D sl Programming And Operating Manual page 98

Manual machining
5.4 Manual machining using cycles (functions)
Parameter
Angle α
Max. infeed depth m1
Finishing m2
allowance
The following possibilities exist for the position of the geometry:
Figure 5-58
Figure 5-59
See also
General parameters (Page 58)
Principle operating sequence (Page 54)
98
Description
Angle of the taper to be machined.
The reference point is either d1 or d2 depending on which dimensioning type is selected.
Enter the maximum infeed depth for roughing. The internal infeed calculation ensures that
the infeed is as uniform as possible throughout the roughing operation. This entry value
represents the maximum value possible and is therefore not exceeded.
Finishing allowance in the X axis (m2x)
Finishing allowance in the Z axis (m2z)
Roughing cycle E, position "Inside right"
Roughing cycle E, position "Outside left"
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
Manual Machine Plus Turning