DataCard SD Series User Manual page 99

5.
Load the new roll of laminator
overlay material.
A.
B.
C.
6.
Close the laminator cartridge gate (f).
Push it in until the latch clicks in
place (g). Make sure that the overlay
material is not pinched by the
cartridge gate.
7.
Replace the loaded laminator
cartridge in the printer.
8.
Remove the L2 (orange) cartridge, if installed, from the laminator.
9.
Repeat steps 3 through 7 to load the overlay onto the cartridge.
10.
Close the laminator access door.
SD Series Card Printer User's Guide
Put the blue supply spool on the
blue supply spindle of the
cartridge (c). The overlay supply
roll can go on only one way and
only fits on the correct spindle.
Put the empty silver take‐up
spool on the silver take‐up
spindle (d).
Turn the take‐up spool clockwise
to remove slack from the
material (e). The overlay
material loads in an S‐shape.
Make sure that the overlay
material is between the guides on
both the take‐up and supply sides
of the cartridge.
A-9