DataCard SD Series User Manual page 44

F.
3.
Remove the used cleaning card. Wait a few minutes for the rollers to dry.
4.
Prepare the printer for use.
A.
B.
C.
D.
32
Insert cleaning card
displays on the LCD panel. If you have a manual feed
printer, insert the cleaning card. Press the U
cleaning cycle.
The printer moves the card through the printer several times and ejects it
into the output hopper.
If you are cleaning an SD460 system, the cleaning card moves into the
laminator after cleaning the printer and cleans the laminator rollers
and card entry area. The cleaning card is ejected into the laminator
output hopper. Refer to Clean the Laminator on page A‐12 for
complete information on cleaning the laminator.
Replace the cards in the input hopper.
Install a new cleaning sleeve on the ribbon cartridge and remove the
protective cover. Refer to "Load the Cleaning Sleeve" on page 20 for the
steps to follow.
Replace the ribbon cartridge and close the printer cover. Press down on
the ridges on the front of the cover to latch it properly.
Press the U button to return the printer to
SER
available to print cards again.
Discard the used cleaning card and cleaning sleeve.
SER
Ready
button to start the
. The printer is
System Maintenance