THOMSON 516 Reference Manual page 549

acname The Access Concentrator name for a PPPoE session.
Tip
servicename The Service Name for a PPPoE session.
Tip
pcomp Try (enabled) or do not try (disabled) to negotiate PPP protocol compression
(LCP PCOMP).
The default is disabled.
accomp Try (enabled), do never try (disabled) or negotiate (negotiate) to negotiate PPP
address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, in other
words, the address field FF-03 should not be sent over ATM.
The default is enabled.
Note
trace Enable or disable verbose console logging.
The default is disabled.
concentrator The access concentrator is on this side of the PPPoE connection.
Choose between:
enabled: the PPP connection is terminated on the Access Concentrator
(here the SpeedTouch™ itself)
disabled: the SpeedTouch™ is PPP client.
The default is disabled.
auth Select the authentication protocol.
Choose between:
pap: Password Authentication Protocol (PAP) authentication will be forced.
chap: Challenge Handshake Authentication Protocol (CHAP) authentication
will be forced.
auto: CHAP authentication will be used. If CHAP authentication is not
successful, PAP authentication will be used instead.
The default is auto.
restart Automatically restart the connection when Link Control Protocol (LCP) link goes
down (enabled) or not (disabled).
The default is disabled.
retryinterval A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level.
The default is 10.
passive Put the link in listening state in case LCP times out (enabled) or not (disabled).
This parameter allows to determine whether the link should be left open to wait
for incoming messages from the remote side after 10 unsuccessful tries to
establish the connection or not.
The default is disabled.
silent Do not send anything at startup and just listen for incoming LCP messages
(enabled) or retry up to 10 times to establish the connection (disabled).
The default is disabled.
E-DOC-CTC-20060414-0002 v1.0
Use the command :ppp ifscan to obtain the names of available
access concentrators, if any.
Use the command :ppp ifscan to obtain the available service
names, if any.
If the accomp parameter is set to "negotiate", the local side of the PPP
connection demands to do ACCOMP and adapts itself to the result of
this negotiation.
PPP Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
529