Atm Ifconfig - THOMSON 516 Reference Manual

ATM Commands

atm ifconfig

Configure an ATM interface.
The interface to be configured must not be connected at the time of configuration. If this should be the
case, use the command :atm ifdetach before using the command :atm ifconfig.
SYNTAX:
atm ifconfig
where:
intf The name of the ATM interface to be configured.
dest The WAN destination for this ATM interface.
Typically, an ATM phonebook entry.
qos The name of the Quality of Service (QoS) book entry to apply on this ATM interface.
The default is default.
encaps The type of encapsulation to be used for this ATM interface.
Choose between:
llc: Logical Link Control (LLC) / Sub Network Access Protocol (SNAP)
vcmux: Virtual Channel MUltipleXing (VCMUX).
The default is llc.
fcs Enable or disable the inclusion of the Ethernet Frame Check Sequence (FCS) in the
packet header on the WAN side (only used for llc encapsulation for mac).
The default is disabled.
Note
retry A number between 0 and 65535.
Represents the number of times the SpeedTouch™ retries to set up a WAN connection
before giving up.
The default is 10.
ulp Select the Upper Layer Protocol (ULP) for this interface.
Choose between:
ip
mac
Routed PPPoE or a PPPoE Relay interface).
ppp
The default is ip.
16
intf = <string>
[dest = <string>]
[qos = <string>]
[encaps = <{llc | vcmux}>]
[retry = <number{0-65535}>]
[fcs = <{disabled | enabled | auto}>]
[ulp = <{ip | mac | ppp}>]
This parameter is normally left disabled.
(for a Routed IPoA interface).
(for a Bridged Ethernet, Routed ETHoA, Bridged PPP over Ethernet (PPPoE),
(for a Routed PPP over ATM (PPPoA) interface).
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20060414-0002 v1.0