Dyndns Modify - THOMSON 516 Reference Manual

DynDNS Commands

dyndns modify

Modify a dynamic DNS client.
SYNTAX:
dyndns modify
where:
name The name of the dynamic DNS client to be modified.
intf The dynamic DNS client interface.
Note
user The username for dynamic DNS authentication.
password The password for dynamic DNS authentication.
group The dynamic DNS host group.
mx The mail exchanger.
backmx Set up the mail exchanger as a backup mail exchanger (enabled) or not (disabled).
The default is disabled.
wildcard Allow the use of hostname wildcards (enabled) or not (disabled).
The default is disabled.
offline Set the host to offline mode (enabled) or not (disabled).
The default is disabled.
service The dynamic DNS service. Choose between:
status Enable or disable the dynamic DNS client.
The default is disabled.
trace Enable or disable the verbose console logging for the dynamic DNS client.
The default is disabled.
218
name = <string>
[intf = <string>]
[user = <string>]
[password = <password>]
[group = <string>]
[mx = <string>]
[backmx = <{disabled | enabled}>]
[wildcard = <{disabled | enabled}>]
[offline = <{disabled | enabled}>]
[service = <{dyndns | statdns | custom | No-IP | DtDNS
| gnudip}>]
[status = <{disabled | enabled}>]
[trace = <{disabled | enabled}>]
This parameter must be defined to enable the dynamic DNS client.
dyndns
statdns
custom
No-IP
DtDNS
gnudip.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20060414-0002 v1.0