Electrical system
Engine oil pressure sensor
ENGINE OIL PRESSURE SENSOR
Function: it indicates to the instrument panel if
there is enough oil pressure (0.5 +/- 0.2 bar (7.25
+/- 2.9 PSI)) in the engine.
Operation / Operating principle: normally closed
switch. With oil pressure above 0.5 +/-0.2 bar (7.25
+/- 2.9 PSI), open circuit.
Location on the vehicle: right side of the vehicle,
under the oil sump
Pin-out: Voltage 5V
Instrument panel
Error DSB 07
Error cause
•
An oil sensor failure is signalled when,
with engine off, it is detected that the
sensor circuit is open. The test is per-
formed only once when the key is set
to ON. This error is signalled by the
bulb icon and the general warning light
turns on as well.
Troubleshooting
•
Check the sensor connector and the
instrument panel connector (PIN 17): If
not OK, restore. If OK, check the con-
tinuity of the purple cable between the
sensor connector and the instrument
panel connector PIN 17: if not OK, re-
store the cable harness; if OK, replace
the sensor.
ELE SYS - 66
SL 750 SHIVER