Battery Installation - APRILIA SL 750 SHIVER Service Station Manual

Electrical system
•
Check the VEHICLE connector of the Marelli control unit, the filter housing large connector
and the throttle control unit connector: if not OK, restore. If OK, check continuity between
the Marelli control unit and the throttle control unit connector from VEHICLE PIN 55 to PIN
B7 and from PIN 56 to PIN A7: if not OK, restore. If OK, check that with throttle control unit
connector disconnected and with key set to ON, there is no voltage on PINS A7 and B7: if
there is voltage, replace the cable harness. If there is no voltage, check that PINS A7 and
B7 are insulated from ground connection: if they are not insulated from the ground connec-
tion, replace the cable harness. If they are insulated, replace the throttle control unit or the
Marelli control unit.
AXONE: NOTES
After installing the control unit and setting the key to ON, wait for 3 seconds, time during which the
control unit detects the throttle valve position.
Connect to Axone and check that the status for Throttle Self-learning is Carried out and the status
for Throttle grip autodetection is Not carried out(this last status entails Urgent service being dis-
played on the instrument panel).
If Throttle Self-learning shows Not carried out , go to stage 1. If it shows Carried out, go to stage 2.
Stage 1: current errors have probably been detected by the control unit: solve these malfunctions and
check the Throttle Self-learning status again. Throttle Self-learning can also be checked from the Pa-
rameter adjustment (screwdriver and hammer) screen page.
Stage 2: Carry out the Throttle Self-learning from the Parameter adjustment (screwdriver and hammer)
screen page and check that Throttle Self-learning status is Carried out. If it is not correct or the voltage
detected on the throttle is out of scale (check with Axone) or if current errors are probably detected by
the control unit: solve these malfunctions and repeat the procedure.
Battery
Characteristic
Battery
12V - 10 Ah

Battery installation

NOTE
ELE SYS - 30
SL 750 SHIVER