Back Side - APRILIA SL 750 SHIVER Service Station Manual

SL 750 SHIVER
TABLE O - GROUND LEAD AND START-UP
CABLE
1. Direct the cable as shown in figure.
2. Before fitting the cable, push the sheath to
the panel terminal so as to hide the RED ca-
ble (see box).
3. Fasten the cable with a clamp 10-mm (0.39
in) long.
TABLE P - GROUND LEAD AND START-UP CA-
BLE
1. Fasten the cable with clamps where indica-
ted.
2. Be careful not to hold the MAP sensor
pipe with the clamp.
3. Place the cable harness as shown.

Back side

CAUTION
ONCE THE ELECTRICAL SYSTEM IS REFITTED, THE CONNECTORS RECONNECTED AND
CLAMPS AND RETAINERS RESTORED, CARRY OUT THE CHECKS INDICATED UNDER "SPE-
CIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES" IN THE "ELEC-
TRICAL SYSTEM INSTALLATION" SECTION.
TABLE A - REAR LIGHT CABLE HARNESS
1. Rear right turn indicator: BLACK and RED cables.
2. Left turn indicator: BLACK and SKY BLUE cables.
3. Fasten the rear light cable harness to the rear frame with two small clamps.
4. When fitting the cable harness, make sure that the cable harness sheathing is visible in the indi-
cated area of the curved support.
Electrical system
ELE SYS - 17