APRILIA SL 750 SHIVER Service Station Manual page 235

SL 750 SHIVER
ALWAYS REPLACE BOTH BEARINGS.
ALWAYS REPLACE THE BEARINGS WITH OTHERS OF THE SAME TYPE.
GASKETS
•
Check that the gaskets are in good conditions; replace them if they show signs of damage
or excessive wear.
ALWAYS REPLACE BOTH GASKETS.
ALWAYS REPLACE THE GASKETS WITH OTHERS OF THE SAME TYPE.
WHEEL PIN
•
Using a dial gauge, check the wheel
pin eccentricity. If the eccentricity ex-
ceeds the limit value, replace the wheel
pin.
Characteristic
Maximum eccentricity:
0.25 mm (0.0098 in)
•
Using a dial gauge, check that the ra-
dial (A) and the axial (B) eccentricities
of the rim do not exceed the limit value.
An excessive eccentricity is usually
caused by worn or damaged bearings.
Replace the rim if, after replacing the
bearings, the value is not within the
specified limit.
Characteristic
Maximum radial and axial eccentricity:
2 mm (0.0079 in)
Suspensions
SUSP - 5