APRILIA SL 750 SHIVER Service Station Manual page 58

Troubleshooting
•
61 - REPLACE THE START-UP RELAY 36 - END
•
62 - REPLACE THE STARTER MOTOR - END
•
63 - RESTORE THE CABLE HARNESS - END
•
64 - WHAT DOES THE "FALL SENSOR" STATUS ON AXONE (DEVICE STATUS/ICON
"0/1" SCREEN PAGE) MEAN?
If "NORMAL" is shown, go to 65; If "TIP OVER" is shown, go to 68
•
65 - WITH THE SWITCH SET TO "RUN", WHAT DOES THE "RUN-STOP SWITCH" STA-
TUS ON AXONE ("DEVICE STATUS/ICON "0/1" SCREEN PAGE) MEAN?
If "RUN" is shown, go to 66; If "STOP" is shown, go to 67
•
66 - USING AXONE CHECK THAT THE SIDE STAND, NEUTRAL SENSOR AND CLUTCH
SENSOR FUNCTION CORRECTLY; OPERATE ANY DEVICE AND CHECK THE SUITA-
BLE INDICATION ON THE "DEVICE STATUS/ICON "0/1" SCREEN PAGE
If "MALFUNCTION" is shown, go to 71; If "CORRECT OPERATION" is shown, go to 72
•
67 - REFER TO THE CHAPTER ON "ELECTRICAL SYSTEM/CHECKS AND CONTROLS/
FALL SENSOR; INDICATION ON AXONE ALWAYS STOP- END
•
68 - IS THE SENSOR VERTICAL?
•
69 - REFER TO THE CHAPTER ON "ELECTRICAL SYSTEM/CHECKS AND CONTROLS/
FALL SENSOR; INDICATION ON AXONE ALWAYS TIP OVER - END
•
70 - SET THE SENSOR TO THE CORRECT POSITION - END
•
71 - ACCORDING TO THE FAILURE, REFER TO CHAPTER ON "ELECTRICAL SYSTEM/
CHECKS AND CONTROLS/GEAR IN NEUTRAL SENSOR", or "CLUTCH LEVER SEN-
SOR" or "SIDE STAND SENSOR" - END
•
72 - REPLACE THE CONTROL UNIT - END
TROUBL - 8
YES, go to 69; NO, go to 70
SL 750 SHIVER