Setting Up - Omron E5AK User Manual

CHAPTER 2 PREPARATIONS

2.1 Setting up

J Draw-out
Fixing Screw for
Front Panel
2--2
· On a standard type controller, set up the output units for control outputs
1 and 2 before mounting the controller.
· On a position-proportional type controller, the relay output unit is
already set. So, this setup operation unnecessary. (Do not replace with
other output units.)
· When setting up the output units, draw out the internal mechanism
from the housing and insert the output units into the sockets for control
outputs 1 and 2.
When drawing out the internal mechanism from the housing, prepare a
phillips screwdriver matched to the size of the screw on the lower part of
the front panel.
(1) Press down on the hook on the top of the front panel and turn the phil-
lips screwdriver to the left to loosen the screw on the lower part of the
front panel.
(2) Draw out the internal mechanism towards you holding both sides of
the front panel.
Tighten this screw by a torque of 0.3 to 0.5 N×m, or approx. 3 to 5 kgf×cm.