Structure Of Parameters - Omron E5AK User Manual

CHAPTER 7 CALIBRATION

7.1 Structure of Parameters

Thermocouple 1
Transfer output
Data save
7--2
· To calibrate the E5AK controller, select [
select the calibration mode. [
· However, note that [
when, for example, the user is calibrating the E5AK controller for the
first time. If this happens, [
rity" parameter (protect mode) to "0".
· The parameters in the calibration mode are configured as follows.
Platinum resistance
Thermocouple
thermometer
Thermocouple 2
Only when transfer
output function is
supported
· To select the desired parameter, press the
played in the following order:
Calibration of inputs ® Calibration of transfer output ®
Saving of calibration data
If the E5AK controller does not support the transfer output function,
calibration of transfer output is automatically deleted from the calibra-
tion procedure as follows:
Calibration of inputs ® Saving of calibration data
· Only inputs that have been set in the "input type" parameter (setup
mode) can be calibrated. To temporarily save data for each of the calibra-
tion parameters, press the
· Transfer output can be calibrated only when the communications unit
(E53-AKF) is set in the controller. To adjust data items, press the
or keys.
· The data save menu is displayed only when all calibration items have
temporarily been saved.
· After calibrating input, you must always check indication accuracy. For
details, see page 7-12.
] is displayed.
] may not be displayed on the menu display
] is displayed by changing the "secu-
Current input
Thermocouple 1 : K1/J1/L1/E/N/W/PLII
Thermocouple 2 : K2/J2/L2/R/S/B/T/U
Platinum resistance
: JPt100/Pt100
thermometer
key for 1 second.
] in the menu display to
Voltage input
0 to 5V 1 to 5V 0 to 10V
key. Parameters are dis-