J Setting up the output unit
F Before setup
F Procedure
· Check the type of the output unit you are about to set up.
· For details on types of output unit and main specifications, see page 2-9.
(1) Check the positions of the sockets you are about to insert the output
units into as shown in the following diagram.
OUT1
OUT2
Bracket
(2) Insert the output unit for control output 1 into the socket "OUT1"
and the output unit for control output 2 into the socket "OUT2".
(3) Fasten the output units with the bracket (accessory).
2.1 Setting up
2--3