Omron E5AK User Manual page 14

F Event input
J Output
F Output assign-
ments
When using event input, add on the input unit (E53-CKB).
You can select from the following five event inputs:
Multi-SP
Run/Stop
Remote/Local
Auto/Manual
SP mode
The E5AK supports the following five outputs.
Control output 1
Control output 2
Auxiliary output 1
Auxiliary output2
Transfer output
When using control outputs 1 and 2, set the output unit (sold separately).
Nine output units are available to suit the output circuit configuration.
When using transfer output, add on the communication unit (E53-AKF).
Note: The output functions of the E5AK do not operate for five seconds af-
ter the E5AK is turned ON.
The E5AK supports the following ten output functions.
Control output (heat)
Control output (cool)
Alarms 1 to 3
HBA
LBA
Error 1 (input error)
Error 2 (A/D converter error)
Error 3 (RSP input error)
Assign these output functions to control output 1, control output 2, auxil-
iary output1, and auxiliary output2.
However, note that as control output 1 is used as the open output and con-
trol output 2 is used as close output on a position-proportional type con-
troller (E5AK-PRR2), control outputs 1 and 2 cannot be used as assign-
ment destinations. Also, of the output functions, control output (heat),
control output (cool), HBA and LBA are disabled.
On a standard type controller, there are restrictions on how assignment
destinations (control output 1, control output2, auxiliary output1, and
auxiliary output2) can be used. For details, see 3.3 Setting Output Specifi-
cations.
In the example on the previous page, "control output (heat)" is assigned
to "control output 1", "alarm 1" is assigned to "control output 2", and
"alarm 2" is assigned to "auxiliary output 1". Accordingly, the configura-
tion is such that heating control output is connected to control output 1,
and alarm output is connected to control output 2 and auxiliary output 1.
1.1 Names of parts
1--5