Omron E5AK User Manual page 79

CHAPTER 5 PARAMETERS
Level 1 Mode
· The parameters in this mode can be used only when the "security" parameter (pro-
tect mode) is set to "0" to "3".
· This mode contains the main parameters for adjusting control. These parameters
include parameters for executing AT (auto-tuning), setting the alarm values, setting
the control period, and setting PID parameters.
· To select this mode when in the levels 0 and 2, setup, expansion, option and calibra-
tion modes, press the
menu display. If you select [
controller enters the level 1 mode.
· To select parameters in this mode, press the
use the
· The following table shows the parameters supported in this mode and the page where
the parameter is described.
5--10
key for 1 second minimum. The display changes to the
or keys.
Symbol
AT Execute/Cancel
Set point 0
Set point 1
Set point 2
Set point 3
Alarm value 1
Alarm value 2
Alarm value 3
Proportional band
Integral time
Derivative time
Cooling coefficient
Dead band
Position-proportional dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout
] then press the key for 1 second minimum, the
key. To change parameter settings,
Parameter Name Page
5-11
5-11
5-11
5-11
5-11
5-12
5-12
5-12
5-12
5-12
5-12
5-13
5-14
5-14
5-15
5-15
5-15
5-16
5-16
5-17
5-17