Omron E5AK User Manual page 122

Parameter No.
00 PV monitor
86 SP monitor during SP
ramp
04 MV monitor (heat)
42 MV monitor (cool)
24 Remote SP monitor
14 Valve opening monitor
01 Set point
10 Set point 0
11 Set point 1
12 Set point 2
13 Set point 3
02 Alarm value 1
03 Alarm value 2
41 Alarm value 3
19 Proportional band
20 Integral time
21 Derivative time
22 Cooling coefficient
09 Dead band
87 Position-proportional dead
band
23 Manual reset value
06 Hysteresis (heat)
43 Hysteresis (cool)
07 Control period (heat)
08 Control period (cool)
17 Heater current monitor
18 Heater burnout alarm
*1 Possible only during reading
*2 During temperature input, the range becomes the range of use of the selected sensor.
*3 During heating and cooling control, the range becomes 0.0 to 105.0.
*4 During position-proportional control, the range becomes 1 to 3999.
About invalid
parameters
Parameter
*1
Scaling lower limit -10% to scaling upper limit +10%
*1
*1
*1
*1
*1
*1
Currently, if a command is used for invalid parameters (parameters that do not sat-
isfy the conditions of use in Chapter 5), the "undefined" error (end code: 1C) is out-
put.
6.4 Commands and Responses
Data Setting and Monitor Range
SP lower limit to SP upper limit
-5.0 to 105.0
0.0 to 105.0
Scaling lower limit to scaling upper limit
-10.0 to 110.0
SP lower limit to set point upper limit
SP lower limit to SP upper limit
SP lower limit to SP upper limit
SP lower limit to SP upper limit
SP lower limit to SP upper limit
-1999 to 9999
-1999 to 9999
-1999 to 9999
0.1 to 999.9
0 to 3999
0 to 3999
0.01 to 99.99
-19.99 to 99.99
0.1 to 10.0
0.0 to 100.0
0.01 to 99.99
0.01 to 99.99
1 to 99
1 to 99
0.0 to 55.0
0.0 to 50.0
Mode
*2
*3
Level 0 L l
*4
Level 1
6--7