Selecting Parameters; Fixing Settings; Manual Mode - Omron E5AK User Manual

F Setup mode
F Expansion mode
F Option mode
F Calibration mode
F Protect mode
F Manual mode
J Selecting
parameters
J Fixing settings
· If you select [ ] [
setup, expansion, option and calibration modes, respectively, are
selected.
· When these modes are selected, the control is reset. So, control outputs
and auxiliary output are turned OFF. When another mode is selected
while in these modes, reset is canceled.
· To set the controller to the protect mode or to return to the level 0 mode
from the protect mode, press the
mun simultaneously.
· To set the controller to the manual mode, press the
minimun in the level 0 to 2 mode. To return to the level 0 mode from the
manual mode, press the
· When not in the manual mode, each press of the
parameter.
· If you press the key when at the final parameter, the display returns
to the first parameter.
Parameter
Parameter
1
· When you have changed a parameter setting, specify the parameter
using the or
seconds or press the
· When another mode is selected, the content of the parameters before the
mode was selected is fixed.
· When turning the power OFF, you must first fix the settings and param-
eter contents (by pressing the
settings and parameter contents are sometimes not changed by merely
pressing the or
] [ ] or [
key and
A/M
key for 1 second minimum.
A/M
Parameter
2 3
keys, and either leave the setting for at least two
key. This fixes the setting.
key or selecting another mode). The
keys.
1.1 Names of parts
] in the menu display, the
key for 1 second mini-
key for 1 second
A/M
key switches the
Parameter
n
1--9