Omron NB-series Operation Manual page 252

3 Functions of NB-Designer
Trigger
Mode
Execution
Cycle
Response
Mode
Trigger
State
Repeat
Count
Trigger
Address
2
Switch to the [Timer Function] tab:
Execute Macro: The Macro code to be executed for each timing reached to the time set by the
Data Transmission: The data transmission will be performed. The data will be transformed
Source Address: Refers to the starting address that the data will be transferred from.
Destination Address: Refers to the starting destination address that the data will be transferred to.
Memory Type: Used to select among "Word" or "Bit" for the memory type to be transmitted.
3-210
Descriptions of Timer Properties
Trigger Address When the address specified at [Trigger Address] matches to the
status specified at [Trigger State], the triggering operates. If [Repeat
Count] is set to "0", the triggering operation is consecutively repeated
until the trigger condition is released. After the trigger condition is
cleared once, followed by the trigger is operated for the number of
times specified at [Repeat Count], the timer will be stopped
automatically.
It refers to the timing cycle of the timer with the unit of 100 ms. The timer will perform
functional operation once at each interval of timing cycle.
Immediate When the triggering condition is met, the function will be executed
immediately.
Delay When the triggering condition is met, the function will be executed
after one cycle is delayed.
When "Trigger Address" is selected, the triggering state of the memory is On or Off.
It refers to the times of repeated execution after the timer is triggered. When it is "0", the
function will always be executed.
After "Trigger Address" is selected, it needs to specify the address to be the trigger.
executing cycle. (Refer to 3-9-3 Macro Triggering (Page 3-268))
from the specified addresses as ([Source Data]) to the specified
addresses as ([Destination Address]) for each timing reached to the time
set by the executing cycle.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)