Omron NB-series Operation Manual page 139

(4) Perform the test and select "33333" in the list component, and "3" will be displayed in the
State No.
Dropdown List: When this component is touched, one list will pop up under this component. All the
For example:
(1) Create one Word Switch with read address and write address both of LW0 and one Number
Display component with the address of LW0.
(2) Set the Control Mode and State No. to "Dropdown List" and "6" respectively.
(3) Set the label contents to "00000" to "55555".
(4) When performing the offline test and selecting the list, the status will be displayed with a list
shown in the following figure on the right.
(5) Touch this component, and the list option will pop up as the above right graphics shown.
(6) After one option is selected, the list will disappear automatically.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
options are available in this list, and it will automatically disappear when one option
is selected.
3 Functions of NB-Designer
3
3-97