Command Button - Omron NB-series Operation Manual

Read Address: Bit address controls the display information of Bit Switch such as the status,
Write Address: Bit address writes the status of On or Off controlled by the Bit Switch.
Address: Refers to the Read/Write Address corresponding to the switch.
2
Switch to the [Bit Switch] tab and set switch type.
Types and Functions of Switch
Type
Set
Reset
Alternate
Momentary
3
Switch to the [Label] and add the text corresponding to the state.
4
Switch to the [Graphics] tab, and select Vector Graphics or bitmap to display the bit address
state and represent the touching area.
5
Switch to the [Control Setting] tab and make the Security Setting and set the Triggering action.
6
Press the [OK] button to complete the setup of the Bit Switch component.
3-6-4

Command Button

Command Button component also defines a touching area and the state value will be input
into the specified word address when the area is enabled.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
graphic, and label.
The specified bit address will turn On when the component is pressed. The state
remains even if the component is released.
The specified bit address will turn Off when the component is pressed. The state
remains even if the component is released.
The state of the specified bit address will change once (On Off On) when the
component is pressed each time.
The specified bit address state will turn On or Off when the component is pressed or
released respectively.
3 Functions of NB-Designer
Descriptions
3
3-87