Table 6-2 Position After Ptz Sessions Close - Honeywell Rapid Eye Administrator's Manual

Pan, Tilt, and Zoom (PTZ) Setup
104
2. Click the Video tab.
3. Click PTZ. Check if the Enable box is selected. Post-session behavior cannot be set
unless PTZ is enabled.
4. Click the When Live Closes drop-down arrow and select a post-session behavior
(behaviors are listed in
Table 6-2 Position After PTZ Sessions Close
At Session End Comment / Behavior
Stay put The camera remains in the last position used by the operator. If it
is panning, it keeps on panning; if it is not moving, it stays that way,
and so on. The stay put behavior makes available the Return to
Auto-iris and Return to Auto-focus options.
Go to preset 1 The camera returns to preset 1 configured using Multi. See
Configuring a Preset on a PTZ Camera
the first preset of a PTZ camera.
a
Start tour 1 Some camera models can be programmed to move independently
when not in use by an operator. For information on how to program
a PTZ tour, see the documentation that came with the domes
connected to the Multi-Media unit.
a
A PTZ tour differs from site tours (see
era tours using a monitor at a Multi-Media site.
PTZ and Motion Search
Video recorded while a PTZ dome or camera can be searched for motion. When the camera
is fixed, results are as expected (see
is ineffective on video recorded as a PTZ camera is panning, tilting or zooming. If you plan
to use motion search on a PTZ camera, use Stay put or a preset after close of session. See
Table 6-2. Motion search can also be used to find out when a PTZ camera was moved, if
that camera should not be moving.
Constant Panning and Video Archive
Recording a video feed from a camera that pans constantly requires much more storage. If
the duration of your video archive is a concern, see
Ultrak KD6i Dome Restriction
The return to auto-focus command has no effect on the Ultrak KD6i dome.
Caution Do not use the Return To Auto-Iris command on Ultrak KD6i domes.
Table 6-2).
Touring Many Sites
Motion Search on page 130). However, motion search
Quality
on page 101 to configure
on page 253) and local cam-
on page 137.