Using A Database With View; Creating A Multi Database; Figure 15-3 Admin Logon And Creating A Database - Honeywell Rapid Eye Administrator's Manual

Using a Database with View

Creating a Multi Database

TIP!
Document 800-02953V4 Rev A
03/10
• View can be set to a different Multi db while Admin is running, and vice versa.
• When switching to another Multi db for use with View, a fresh local Multi db overwrites
the local db used at the previous log on.
• Entering the name of a non-existent database in the View logon window is of little
consequence. Acknowledge the error message and enter the name again.
Creating a Multi db is a rare occurrence. Only one Multi db is needed for all of the
Rapid Eye sites in your system. Honeywell recommends using the default
REMCentral.mdb if you plan to use only one Multi database. The installers of your
system may have already created a Multi db to test the installation.
Using the Admin - Logon Window to Create a Database
If the installers did not supply you with their Multi db, you can use Admin to create an empty
Multi db while you are logging on.
Figure 15-3 Admin Logon and Creating a Database
Rapid Eye Multi-Media DVR System Administrator Guide
267