Roland Super JX-10 Owner's Manual page 48

In this setting, the Program Change number which corresponds to the Tone number of the Upper section you have
selected is sent on the MIDI CH 1 of the MIDI Sound Module.
3. Sending two different Program Change numbers separately to two MIDI Sound Modules by changing
Patch Memories on the JX-10.
M I D I S o u n d m o d u l e 1
MIDI .................................... CH 1
PROGRAM CHANGE ........... ON
•
MIDI Setting on the JX-10
[10 PATCH MEMORY ............................. OFF]
[20 UPPER MIDI CH ..................................... 1]
[30 LOWER MIDI CH .................................... 2]
[21 UP PROGRAM CHANGE ................... ON]
[31 LO PROGRAM CHANGE ................... ON]
In this setting, the Program Change number which corresponds to the Tone number of the Upper section in the
Patch Memory you have selected is sent on the MIDI CH 1 of the MIDI Sound Module 1. Likewise the Program
Change number assigned to the Lower Tone number is sent on the MIDI CH 2 of the MIDI Sound Module 2. (only
when the Factors 63 and 64 "PROGRAM CHANGE SEND", of the Patch Memory are set to OFF).
How to assign the Program Change number to the Tone number is the same as the way of 2 on page 45.
The Factors 63 and 64 "PROGRAM CHANGE SEND" of the Patch Memory can be set separately from the value 1
to 128. The Upper and Lower Program Change numbers which you have set in the Factors 63 and 64 are
transmitted independently to each MIDI CH of the MIDI Sound Modules regardless of Program Change ON/OFF
messages ofthe Upper and Lower sections in the MIDI functions.
31 UPPER
Tone number
of the JX-10
1
50
100
MIDI THRU
MIDI IN
JX-10
MIDI OUT
TONE NUMBER
41 LOWER
1 2
1 2
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
MIDI Program Change number
which is sent
MIDI IN
PROGRAM CHANGE
SEND
63 UPPER 64 LOWER
OFF OFF
3 4
Pag. 48 of 53
1
50
100
M I D I S o u n d m o d u l e 1
MIDI ................................... CH 2
PROGRAM CHANGE ........... ON
PROGRAM CHANGE
NUMBER
UPPER LOWER
1 2
3 4