Roland Super JX-10 Owner's Manual page 23

P a r a m e t e r
Display
Number
DCO 1 LFO
14
DCO-1 Lfo Depth
26 DCO 2 LFo
DCO-2 Lfo Depth
DCO 1 ENV
15
DCO-1 Envelope Depth
DCO 2 ENV
23
DCO 1 Xmod
27
Cross Modulation
DCO 2 FTUN
25
DCO-2 Fine Tune
DCO DYNA
31
DCO Dynamics Range
DCO MODE
32
DCO Envelope Mode
Data
Value
When the LFO output is modulating the DCO, this
parameter is used to adjust the depth of the
modulation. For vibrato effect, select "SINE" with
the LFO Depth LFO Waveform
99
When the ENV output is modulating the DCO, this
parameter is used to adjust the depth of the
00
modulation.
• XMOD: The pitch is determined by DCO-1, and
the harmonic contents by DCO-2. The waveform
is determined by the DCO-2's synchronization to
XMOD
DCO-1
SNC2
• SNC2
SNC1
• SNC1
OFF
harmonic contents and waveform
• OFF: Each DCO-1 and DCO-2 can have
different pitch and waveform
The frequency (pitch) of the DC0-2 can be adjusted
+50
with this parameter.
*Variable range ±50 cent
-50
When the DCO's pitch is controlled by the ENV, and
3
the amount of the ENV is controlled by Dynamics
2
(Key Touch), this parameter adjusts the sensitivity of
1
Key Touch. (Note 1)
off
This selects the polarity of the Envelope curve.
-1
Normally, is used.
pattern will be inverted.
-2
-2
-2
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 23 of 53
F u n c t i o n
Both SYNC 1 and X MOD work together.
:
DCO-1 and DCO-2 affect each other,
:
In mode,
Programmer
ADSR