Roland Super JX-10 Owner's Manual page 15

b. Tone Number
To change the Tones in a Patch Memory, simply assign the Tone Number of the relevant Tone by using the Ten
Keys (i.e. Numeric Keypad).
PROCEDURE
1. Push the Upper or the Lower Button to select the Upper or Lower Tone which you wish to change.
2. Pushing the appropriate Ten Keys, assign the new Tone Number, then hit the Enter Key.
*"0" of the Ten Keys can be used instead of the UPPER and LOWER Buttons.
Even when using the Patch Memory of the JX-10's internal memory, the Tone Number of the Cartridge can be
called.
After taking the step 1., change the Voice Memory Switch to the CART position. Then return it to the INT position
after taking the step 2.
If you call other Patch Memory without writing it into memory, the Tone called from the Cartridge memory will be
erased.
To call the Tone from the Memory Cartridge (M-16C), take exactly the same procedure as above. The available
Tone Numbers, however, are from 1 to 32.
c. Chase Play
The Chase Play function makes it possible to output the Lower sound slightly later than the Upper sound. This
function, however, is available just in the Dual Mode.
Depending on the delaying time and the Tone in use, the effects created differ; delay-like effect, sound-on-sound
like effect etc.
PROCEDURE
1. Push ON/OFF of the Chase Play Buttons: The corresponding indicator will light up, showing that now the
Chase Play function is turned on.
2. Set the following 3 functions: Time, Level and Mode so that the desired effect will be obtained.
The "Level" and "Mode" are alternately selected by pressing the FUNCTION of the Chase Play Buttons.
The Display shows the function selected. The "Time" function can be selected by pressing the TIME of the Chase
Play Buttons. The value of the selected function can be changed by using the α Dial.
1) Level
This sets the level of the delayed sound (= lower sound). Rotating the α Dial, set the value you like. The value
changes from 00 to 99, and the higher number sets higher level.
**
51 chase play level
**: 00 to 99
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 15 of 53