Roland Super JX-10 Owner's Manual page 44

36 UPPER PORTAMENTO
37 UPPER HOLD
38 LOWER MIDI VOLUME
41 COMPATIBILITY
41 EDIT DISPLAY
41 C1 C2 TONE EDIT
After the edition session is completed, press <WRITE> button, rotate the α Dial until the display shows "Write MIDI
Settings?" is found, then press <ENTER> to save.
**
OFF - RCV - SEND - ON
**
OFF - RCV - SEND - ON
**
OFF - RCV - SEND - ON
**
OFF - 1 - 2
**
OFF - PG800 - SySEX
PG800-SYSEX
C1 C2 - PG800 C1 C2
**
ON - OFF
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 44 of 53
OFF = Lower neither receives nor sends portamento
RCV = Lower receives portamento only
SEND = Lower sends portamento only
ON = Lower sends and receives portamento
OFF = Lower neither receives nor sends CC#64 -
hold
RCV = Lower receives CC#64 - hold only
SEND = Lower sends CC#64 - hold only
ON = Lower sends and receives CC#64 – hold
OFF = Lower neither receives nor sends CC#7
RCV = Lower receives CC#7 only
SEND = Lower sends CC#7 only
ON = Lower sends and receives CC#7
Used to slow down sys-ex data transmission from
the JX-10 to old librarian softwares.
OFF = sys-ex data sent at full speed
1 = slower mode 1
2 = slower mode 2 (slower than mode 1)
In compatibility 2, a sysex coming for tone-A is
•
redirected to the currently selected tone. Some
old software also relies on this
According to the JX-10 display will or won't show
Edit parameters.
OFF = Edit parameters are not shown
PG-800 = Edit parameters are shown when PG-800
controls are moved
Sysex = Edit is accomplished by an external editor
that send and receives sys-ex data
PG800 – Sysex = Combination 1 of the above
C1 C2 = Edit parameters with C1 C2 assignable
sliders
PG-800 – C1 C2 = Combination 2 of the above
C1 C2 – Sysex = Combination 3 of the above
PG – C1 C2 – SYS = All of the above
Tone editing can be accomplished with C1 C2
assignable sliders