Roland Super JX-10 Owner's Manual page 11

b. Function of the Control Knobs
The following controls can be operated even while you are playing the JX-10.
a. Control Assign Sliders
Each of these two sliders can be used for controlling the performance control function you select with the Control
Assign Button. (See page 11 "3. Control Assign")
b. Bender lever – Bend Range Switch
This Bender Lever can be used during live performance for creating guitar's chocking-like effect. The left and right
extremes of movement create the same amount of pitch bending effect. The maximum effect of the bender can be
selected with the Bend Range Switch: major 2
Pushing this lever forward will create the vibrato effect. When the tone you are using has already taken in a vibrato
effect, the effect will be deepened.
c. Aftertouch Fine Adjust Slider
The Aftertouch effect is the sound's alteration obtained by pressing the key stronger after playing it in a normal
manner. The JX-10's aftertouch effect works on the Vibrato, Brilliance and Volume.
Vibrato: The depth of the vibrato effect is deepened.
Brilliance:
The tone will become brighter.
Volume: The volume of the sound will increase.
The setting of On/Off or value of each aftertouch
effect can be written in each Patch Memory
independently, but the Aftertouch Fine Adjust Knob
allows even more delicate adjustment of the effect
When this knob is set to the center position, the
same effect as set in the Patch Memory can be
obtained, and no effect is obtained at the lowest
position [-].
* Different On/Off settings and values of the
aftertouch and bender are written in each of the 64
Patch Memories. Therefore, those effects you
actually gain will greatly differ depending on how
these are set in the Patch Memories: No effect may
be obtained in some particular settings.
d. Voice Memory Switch
This switch selects which memory mode; the JX-10's internal memory or the Cartridge memory to be used.
Patch You can call a Patch Memory
Memory
Tone
Even after you have changed the Memory modes with the Voice Memory Switch, the new position – does not affect
the memory unless you select a new Patch Memory.
When you select a new Patch Memory, "I" (internal) or "C" (cartridge) is shown at the left end of the Display,
depending on which position has been selected with the Voice Memory Switch.
* When the Memory Cartridge is not connected, be sure to set the Voice Memory Switch to the INT position.
CART
in the Cartridge
Tone Numbers 1 to 50
= Tones in the Cartridge
Tone Number 51 to 100 =Tones in the JX-10
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
nd rd rd
, minor 3 , major 3 , perfect 5th, perfect octave higher or lower.
You can call a Patch Memory in the JX-10
Tone Number 1 to 50
= Tones in the JX-10
Pag. 11 of 53
INT