Roland Super JX-10 Owner's Manual page 29

6. ARPEGGIATOR
This is a brand new function in place of the original sequencer, useless for today's standards, featured in the JX-
10. There are 8 arpeggiator memories that can be recalled through A – H buttons, while the 1 – 7 buttons recall
arpeggiator parameters and settings.
Pressing <FUNCTION> button toggles between ARP and I/C-A1 - H8 Patch.
To revert to Patch press <FUNCTION> button again.
Important note:
•
Arpeggiator always looks at Upper split point.
Button Parameter
1
BPM
2
mode
3
OCTAVE SPAN
4
INSERT
5
PLAY RATE
6
DURATION
7
VELOCITY
8
Unassigned
The new firmware ver. 3.0 allows assigning C1 and C2 sliders to selected arpeggio parameters 1 – 7. To assign
one of the possible seven parameters either to slider C1 or C2:
PROCEDURE
1. Press the <FUNCTION> button. The Display respond with:
ARP-A 1 BPM
2. Press C1 or C2 button
C1 ARPEG 11 BPM
C2 ARPEG 11 BPM
3. with the α Dial select the parameter 1 – 7 to assign either to C1 or C2 slider.
C1 ARPEG 12 MODE
i.e.
C2 ARPEG 15 PLAY RATE
These settings are relevant to the eight arpeggio memories available in the JX-10 and can be saved pressing
<WRITE> button, selecting with the α Dial "Write Arpeggiator" (see pag. 34) and pressing <ENTER> to confirm
operation.
EXTERNAL, 20 - 250
UP, DOWN, UP-DOWN, PLAYED, RANDOM
1, 2, 3, 4
NONE, HIGHEST, LOWEST, UP 3 DOWN 1, UP 4 DOWN 2
1, 1/2 D, 1/2, 1/4 D, 1/2 T, 1/4, 1/8 D, 1/4 T, 1/8, 1/16 D, 1/8 T, 1/16'
1/16 T, 1/32
1 - 15 - LEGATO,
Played, 1 - 127
***
***
***
Up DOWN
1/16
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Values - Range
---
Pag. 29 of 53
Notes
100
Default
UP
Default
1
Default
none
Default
1
Default
Default
LEGATO
played
Default
---