Chase Play - Roland Super JX-10 Owner's Manual

Parameter
#
37 Upper portamento
47 Lower portamento
38 Upper BENDER
48 Lower BENDER

CHASE PLAY

Parameter
#
51 Chase play level
52 Chase play mode
53 Chase play time
The Chase Play function makes it possible to output the Lower sound slightly later than the Upper sound. This
function, however, is available just in the Dual Mode. Depending on the delaying time and the Tone in use, the
effects created differ; delay-like effect, sound-on-sound like effect etc.
PROCEDURE
1. Push ON/OFF of the Chase Play Buttons. The corresponding indicator will light up, showing that now the
Chase Play function is turned on.
2. Set the following 3 functions: Time, Level and Mode so that the desired effect will be obtained.
The "Level" and "Mode" are alternately selected by pressing the FUNCTION of the Chase Play Buttons.
The Display shows the function selected.
The "Time" function can be selected by pressing the TIME of the Chase Play Buttons. The value of the selected
function can be changed by using the α Dial.
# Parameter
51 Chase play level
52 Chase play mode
53 Chase play time
54 Chase play switch
Range
On off
On off
On off
On off
Range
00 to 99
u-l-u-, u-l-l-, u-l
01 to 99
Values - Range
00 to 99
U-L - U-L-L - U-L-U
01 to 99
On off
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 19 of 53
Description
These Factors can turn on or off the Portamento
effects of the Upper and the Lower separately
These Factors can select whether to turn the Bender
functions on or off separately on the Upper and the
Lower
Description
See pag. 13 - 14
Notes
This sets the level of the delayed sound (= lower
sound).
Rotating the α Dial, set the value you like. The
value changes from 00 to 99, and the higher
number sets higher level.
This sets how the delayed sounds are output
sequentially. As you rotate the a Dial, the Display
changes as "U-L-U", "U-L-L" or "U-L".
U-L-U: In this mode, Upper sound is output
•
first, then Lower, Upper, Lower repeatedly.
•
U-L-L: In this mode, Upper sound is output
•
first, then Lower sounds repeatedly.
U-L: In this mode, Upper sound is first output
•
then Lower. No more sound is output.
This sets the time between the first (Upper) sound
and the second (Lower) sound.
Push the TIME of the Chase Play Buttons to turn to
the Time adjusting mode, then change the value
rotating the a Dial. 01 to 99 are valid and the higher
number is longer time.
When you have completed editing all the functions,
hit the Enter Key.
Same as ON/OFF of the Chase Play Buttons