Roland Super JX-10 Owner's Manual page 13

When C1 or C2 is selected , any of the following four functions can be assigned
C - ASSIGn 11 u/l bal
C - ASSIGn 15 porta time
C - ASSIGn 18 total vol
C - ASSIGn 65 up midivol
C - ASSIGn 66 lo midivol
•
With the new firmware, once C1 and C2 are assigned two different Factors, they will be controllable by C1 and
C2 sliders respectively, in real time.
*When PEDAL SWITCH is selected, any of the following four functions can be assigned.
P5 ASSIGn patch shift
P5 ASSIGn portamento
P5 ASSIGn chase play
P5 ASSIGn upper hold
P5 ASSIGn lower hold
-
" " in the Display actually shows 1 or 2 depending which of
** shows the value set in the Patch Memory
Display
Display
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 13 of 53
Adjusts the volume balance of the Upper
and Lower.
**
Raising the Knob increases the Upper
volume, and lowering the Knob increases
the Lower volume.
Adjusts the Portamento Time.
**
Raising the
Portamento Time
Adjusts the volume within the range of the
maximum volume set with the Master
Volume. Raising the Knob raises the
**
volume, reaching the maximum volume. At
the same time, the MIDI volume of the
Upper and the Lower change.
Controls the MIDI messages of the Upper
**
or Lower section
Refer to "MIDI" on page xx.
**
Pressing the pedal changes the bank and
**
the number of the Patch Memory.
A1 → A2 ........ AB → B1 → B2 ........
Turns the Portamento ON or OFF.
**
Turns the Chase Play Function (p. xx)
**
ON or OFF.
Turns ON or OFF the Hold Effect of the
**
Upper and/or the lower section.
**
or is pushed
Description
Knob makes longer
Description