Roland Super JX-10 Owner's Manual page 30

7. WRITING INTO MEMORY
Editing a Patch Memory or Tone does not automatically rewrite the existing data. That is, calling other Patch
memory or Tone will erase the edited data, retaining the existing data.
To retain the edited data, you can overwrite the existing data in the internal memory, or write on the Memory
Cartridge.
You can also change the names of the Patch Memories and Tones. This is called NAMING.
It is possible to edit the Patch Memory, Tones and Names, then rewrite them altogether by one action of the writing
procedure.
NOTE
Rewriting a Tone will naturally change the Patch memories that use that Tone. In other words, if a Tone which is
used in a Patch Memory is rewritten, the newly written Tone replaces the original one,
therefore the Patch memories which used to contain the original Tone will now contain the new Tone. Please
remember this fact, otherwise you may be puzzled at unexpected alteration of the Patch Memories when you call
them later.
a. Writing a Patch Memory
When you want to write the edited Patch Memory, select a location far it from A-1 to H-8. right after editing the
Patch Memory (with the indicator of the PATCH button is lighted) and take the writing operation as follows.
PROCEDURE
1. To write the edited Patch Memory into the JX-10's memory, set the Protect Switch on the JX-10 to the OFF
position. To write onto the Cartridge memory, set the Protect Switch on the cartridge to the OFF position.
2. Push the WRITE button. The display will respond with:
If you wish to write the edited Patch Memory into the same location, in other words, to overwrite it, that is already
shown in the display (Bank and Number), so skip the next step 3 and go to the step 4.
If you wish to write the edited Patch Memory into a different location, take the step 3, then go to 4.
3. Set the Voice Memory Switch to the appropriate position depending on which of the JX-10's memory or
Cartridge memory to be used for the new location, then assign the Bank and the Number of the new location
using the Patch Memory Buttons
4. Push the ENTER key
The Display will respond with as below, showing that the writing is completed, then return to the usual indication
5. Return the Protect Switch to the ON position.
Roland JX-10 Manual – Firmware ver 3.00 ADDENDUM
Pag. 30 of 53