Removing A Hot-Swap Fan Assembly - IBM System x3550 M3 Type 4254 Problem Determination And Service Manual

To install a hot-swap ac power supply, complete the following steps:
1. Read the safety information that begins vii and "Installation guidelines" on page
2. Touch the static-protective package that contains the hot-swap power supply to
3. If you are installing a hot-swap power supply into an empty bay, remove the
4. Grasp the handle on the rear of the power supply and slide the power supply
5. Route the power cord through the handle so that it does not accidentally
6. Connect the power cord for the new power supply to the power-cord connector
7. Connect the other end of the power cord to a properly grounded electrical
8. Make sure that the ac power LED and the dc power LED on the ac power

Removing a hot-swap fan assembly

Attention:
30 seconds.
To remove a hot-swap-fan, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Remove the cover (see "Removing the cover" on page 174).
167.
any unpainted metal surface on the server; then, remove the power supply from
the package and place it on a static-protective surface.
power-supply filler panel from the power-supply bay.
forward into the power-supply bay until it clicks. Make sure that the power
supply connects firmly into the power-supply connector.
become unplugged.
on the power supply.
outlet.
supply are lit, indicating that the power supply is operating correctly. The two
green LEDs are to the right of the power-cord connector.
To ensure proper server operation, replace a failed hot-swap fan within
"Installation guidelines" on page 167.
Chapter 5. Removing and replacing server components
213