Setting The Meter Indication Mode; Setting The Automatic Tuning Start(Ats) - JRC JSS-296 Instruction Manual

3.4.3.8 Setting the meter indication mode

The bar indicator on the bottom of the LCD indicates signal level during reception or output during
transmission, furthermore output indication is settable to the output power mode or antenna current
mode.
Procedure
MENU
1. Press
"METER" blinks .
ENT
2. Press
"PWR" blinks.
3. Turn the Jog Dial until desired mode
appears.
"PWR" : Indication for output power.
"ANT" : Indication for antenna current.
4. Press
ENT
Indication mode, "PWR" or "ANT", is fixed.
3.4.3.9 Setting the Automatic Tuning Start (ATS)
The ATS function is used for pre-tuning at change of channel / frequency, and tuning starts
automatically when the standing-wave ratio (SWR) is wrong.
Procedure
MENU
1. Press
"ATS" blinks.
ENT
2. Press
"OFF" blinks.
3. Turn the Jog Dial to set "ON" or "OFF".
ENT
4. Press
The ATS function is turned "ON" or "OFF" .
3-18
, then turn the Jog Dial until
.
.
, then turn the Jog Dial until
.
.
Examples of display on the LCD
Examples of display on the LCD