How To Attend To Error Detection - JRC JSS-296 Instruction Manual

Note
Dip switch setting for each equipment.
JSS-296(NCT-196N/NDZ-127J)
JSS-825NA/NC(NDZ-127N)
3.8.8

How to Attend to Error Detection

There are two types of errors. When an error is detected, a beep sounds, and the P.OUT lamp blinks 5 times.
(1) Paper discharge error
When the "out of paper" state is not detected, even though an 18 inch line feed procedure is performed, a paper
discharge error will result. The P.OUT lamp remains blinking until the error state is canceled.
When this happens, manually pull the paper out of the printer, or remove the paper automatically by using LF or
FF , then press ONLINE .
(2) Paper sending error
If the paper is not properly set, even though a 10 inch line feed procedure is performed, a paper sending error
results. In addition, if this error happens when the printing instruction is entered, the P.OUT lamp remains blinking
until the error state is canceled.
When this happens, follow the procedure below.
Procedure
1. Press ONLINE switch.
The printer is set to an off-line state.
2. Press FF switch, set the paper, then press ONLINE .
The printer is set to an on-line state.
JSS-825D(NCT-620D)
NCT-196
NCT-196N
JSS-850
JUE-75C(NDZ-127C)
DIP switch setting
DIP switch
ON
OFF
1 2 3 4 5
DIP switch
ON
OFF
1 2 3 4 5
DIP switch
ON
OFF
1 2 3 4 5
6 7 8
6 7 8
6 7 8
3-107