3.8.4
Replacing the Roll Paper
When replacing the paper roll, proceed as follows.
Be sure to turn OFF the printer power when opening and closing the printer cover.
Failure to comply could result in electrical shock, failure, or injury.
Just after printing, the temperature of the printer head is high. Do not touch the printer head
until the temperature goes down.
Failure to comply could result in a burn or injury.
Do not touch any part of the cutter. Doing so may result in injury.
Procedure
1.
Insert the roll bar through the center of the paper roll.
If the leading edge of paper is torn or bent, cut it off in a straight line.
2.
Attach the roll bar with the paper roll onto the paper roll stand unit holder, taking
care to notice he paper roll's direction.
Set the sensor guide lever so that it touches the paper roll.
Perform the consecutive procedures while the printer cover is open.
Note
To open the printer cover, refer to "9.3 Opening/Closing the Printer Cover".
3-98
CAUTION