Using The Main Loudspeaker - Mercedes-Benz COMAND Operating Instructions Manual

Control panel
Hide thumbs Also See for COMAND:
Table of Contents

Advertisement

Insert the new batteries. Observe the
X
polarity markings on the batteries and
battery compartment when doing so.
Left-hand battery: the positive pole (+)
must face upwards.
Right-hand battery: the positive pole (+)
must face downwards.
To close the battery compartment:
X
insert battery compartment cover =
starting with retaining lugs ? into the
battery compartment and allow catch
tab ; to engage in place.
On the cordless headphones
The battery compartment cover is located on
the left headphone.
Battery compartment cover
:
The cordless headphones contain 2 type AAA,
1.5 V batteries.
To open the battery compartment: flip
X
battery compartment cover : upwards.
As you do so, hold the left-hand side of the
headphones as shown to prevent the
batteries from falling out.
Remove the discharged batteries from the
X
tray.
Insert the new batteries. Observe the
X
polarity markings on the batteries and
battery compartment when doing so.
Left-hand battery: the positive pole (+)
must face upwards.
Basic functions
Right-hand battery: the positive pole (+)
must face downwards.
To close the battery compartment:
X
press battery compartment cover
downwards until it engages into place.
If the batteries have been inserted
correctly, the indicator lamp will light up
green when the headphones are switched
on.
Basic functions
Using headphones
You can use the cordless headphones
supplied and/or up to two sets of corded
headphones connected to the corresponding
jack of the rear-compartment screens
(
page 209).
Y
Information on:
switching the cordless headphones on/off
R
adjusting the volume of the headphones
R
selecting a screen for the headphones
R
can be found in the Cordless headphones
section (
page 211).
Y
Using the main loudspeakers
This function is available in conjunction with
COMAND.
You can use the vehicle loudspeakers to
listen to a disc inserted in the rear-
compartment drive. To do so, at least one of
the rear-compartment screens must be set to
disc mode.
To set using COMAND: press, for
X
example, the $ function button to
switch on an audio mode.
Select
Audio
by sliding ZV the COMAND
X
controller and press W to confirm.
The Audio menu appears.
Select
Rear Audio
by turning cVd the
X
COMAND controller and press W to
confirm.
213
Z

Advertisement

Table of Contents
loading

Table of Contents