Mercedes-Benz COMAND Operating Instructions Manual page 108

Control panel
Hide thumbs Also See for COMAND:
Table of Contents

Advertisement

Additional settings
106
Option 1: the menu appears
Select
Using
Map,
X
Personal POIs
If you select
Using
crosshair appears.
After choosing between
From Personal
destination memory (
of categories for personal points of interest
appears (
page 75).
Y
Choose the destination or personal point of
X
interest and press W to confirm.
If the destination address is displayed,
X
select
Continue
The map appears.
The crosshair marks the center of the area
that is to be avoided.
To move the map: slide XVY, ZVÆ or
X
aVb the COMAND controller.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
X
controller.
A red square appears on the map.
From Memory
or
From
and press W to confirm.
Map, the map with the
From Memory
or
POIs, either the
page 94) or the list
Y
and press W to confirm.
To adjust the size of the square: turn
X
cVd the COMAND controller.
The square is enlarged or reduced.
To confirm the settings: press W.
X
The list appears. The previously selected
area to be avoided has been added and
activated.
Follow the instructions listed under "Option
X
2: the list appears".
Option 2: the list appears
"Avoid area" list (example)
i
Available list places are named
<x>
and are shown in gray.
Select
Avoid New Area
X
the COMAND controller and press W to
confirm.
A menu appears.
Area
by turning cVd

Advertisement

Table of Contents
loading

Table of Contents